Announcement

Collapse
No announcement yet.

Follow up on prop issue

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Follow up on prop issue

    Wasn't the prop. Changed props & same thing. Something going on with the motor. Starts fine, idles fine, acts fine in every way until you lower the prop in the water & the rpm drops & no thrust. The deeper you lower the prop the more it lugs down. Lift it back up & up goes the rpms. The diagnosis continues.

  • #2
    Ignition coil(s).

    Comment


    • #3
      coils are probalbly fine, Ronnie check to make sure both cyl have compression then check to make both have spark. Odds are you have a bad diode and only running on one cylinder

      Comment


      • #4
        Fuel. Clean carb if spark checks out
        Working…

        Comment


        • #5
          pull one spark plug wire then the other while it is idling. if there is no change, that coil is bad.

          Comment


          • #6
            Sell on marketplace and buy a new motor.


            Sent from my iPhone using Tapatalk

            Comment


            • #7
              Thanks for the advice fellas ( most of it anyhow). Found oil where it shouldn't be on the right side. Going in the shop Monday.

              Comment


              • #8
                Originally posted by Rebsbud View Post
                Thanks for the advice fellas ( most of it anyhow). Found oil where it shouldn't be on the right side. Going in the shop Monday.
                Hate to hear that, hope they turn it back out quickly.

                Comment


                • #9
                  I was gonna say one cylinder too
                  Blew the soot out of mine today hasnt been run since last year..
                  Trim wouldnt go down and wouldnt idle this morning but we made it to spot. Then after it warmed up this afternoon it started working was able to open her up and clean her out .
                  Damn sure dont need to spend money on that sucker right now
                  Knocking on wood...

                  Comment

                  Working...
                  X